RF FAQ

All my front LED's are green but why do I get a red EXC DRV & PA fault LED when I un-mute my STX?
Check the DB-37 female Failsafe connector for jumper connections between Pin 2 (failsafe) and Pin 12 or 19 (Both Ground). Also make sure the DB-37 connector...
Tue, 8 Oct, 2019 at 10:32 AM
Can I substitute a PA module as an IPA module on my FM 10S / FMi 703 or FM 20S / FMi 1405?
Yes. The PA modules and the IPA modules are interchangeable on the FM 10S / FMi 703 and FM 20S / FMi 1405 series transmitters
Tue, 8 Oct, 2019 at 10:34 AM
Do I need to install lightning protection for my BE transmitter?
Yes, all RF transmitter installations should include lightning protection.  Please view our attached white paper, Protecting Solid State Transmitters Agains...
Wed, 16 Oct, 2019 at 5:41 AM
Does it matter which AC leg is high on my FM 10S / FMi 703 series transmitter?
No. Please refer to the  "FM 10S / FMi 703 FM+HD Transmitter Manual" for power connections.    You can also reference the original customer orde...
Thu, 31 Oct, 2019 at 2:20 PM
Does my HD Multicasting system require Cat6 cables when I implement Exgine Architecture?
Yes. Category 6, (ANSI/TIA/EIA-568-B.2-1) is a cable standard for Gigabit Ethernet and other network protocols that is backward compatible with the Category...
Tue, 8 Oct, 2019 at 10:39 AM
ETG IP Address is Unknown or 0.0.0.0
Problem You are unable to connect to the Web UI of your ETG model transmitter, OR The IP address of your ETG model transmitter appears as 0.0.0.0 on the f...
Thu, 2 Mar, 2023 at 9:03 AM
HD Radio Importer FAQ
See attached document of common FAQs about the Importer IDi 20/40/50 version 4.x.x. or 5.x.x  STS-05-0002 HD Radio Importer FAQ
Tue, 7 Jan, 2020 at 4:39 PM
How can I determine which STX GEN II transmitter B+ power supply is faulting?
Complete question: I have a Red PS LED indicator illuminated on the front panel of the Main PA, how can I determine which STX GEN II transmitter B+ power su...
Tue, 8 Oct, 2019 at 10:42 AM
How do I change the frequency calibration setting of my FM 10S / FMi 703 transmitter?
With TX software version 1.0.34 or greater, the frequency calibration setting can be changed by using a PC connected to the front panel "RTDS PORT"...
Thu, 31 Oct, 2019 at 11:42 AM
How do I un-mute my FX 30/50 or my FM 100C/250C exciter?
Simply add a jumper across Pins 6 & 7 on the rear remote interface terminal block.
Tue, 8 Oct, 2019 at 10:46 AM